You’re leaving out the wanna be criminals who are hoping to get in on the grift. See: the it and groundskeeping staff who helped him hide classified docs.
nilloc
joined 2 years ago
Trump’s hands are too small to push anyone out of a window. Also, the way his full diapers and heel lifts make him lean forward, puts him at too much risk of falling out as well.
If their Russian financiers are in town though…
A lot of citizens coming through footage have been helpful in identifying the seditionists. We need to demand the raw footage and dox the rest of the criminals.
But we’re still gonna pick the non-dictator option by a huge popular vote margin. The other 40% are cheering the dictator.
The problem it’s the swing state morons, who either don’t bother voting or “protest” vote for some third party and end up enabling the fucking dictator. Those are the only possible sleepwalkers. And there really aren’t that many of them.
That’ll be $25k please.
And oddly, neither of them are named Dan.
Name and address goes pretty far, but likely the D or R on your reg will mean the most for these assholes.
Suggesting they were thinking of the “collective interest” of the American people as you stated, was were I took exception.
Dick Cheney and Bush 2 were planning the (re)invasion of Iraq from before 9/11. And tax cuts at all costs beside the military, denial of abortion rights, and deregulation of agencies have been on their platform since Reagan.
Also Bush won his while losing the popular vote and refused to concede in Florida where his brother and the Supreme Court gave him an arguably undemocratic presidency.
Halliburton kids just don’t want to work these days.
Yeah the amount of BS or confidently incorrect in tech articles about automotive engineering is crazy.
And while gear-sets are really efficient, adding 8 to each of the 4 wheels 32 total, in leu of 2-4 at each end of the car, plus 4 CVs (assuming it’s AWD) has to be close in efficiency. And as a DIY+ car restorer in New England. I wanna see how they seal this thing. And with steering wheels it’s either gonna have to swing the motor around or put the CV back in anyway.
NVH (noise vibration harshness) is also going to be a huge factor. That and cost and weight is why we don’t have gear driven camshafts except on a select few exotic motorcycle engines and F1 engines.
Helical gears are the cost effective way to reduce gear noise, but they impart axial loads which would be difficult to overcome in this hinged joint. Herringbone fears eliminate the axial load, but are much harder to make, unless you go with powdered metal sintering. Which I barely trust in a cordless drill, let alone a Kia.
Edit: And no accounting for wheel castor, or camber changes along the suspension travel (way more basic and important for handling than torque vectoring). This video is pure marketing wank.
I’m not going to say no, however my nozzle has been pretty gross for a long time between cleanings and never been an issue.
The bigger danger is that the thermocouple could fail and allow runaway heating (beyond 300c). But most good print firmware is supposed to prevent that.