Just played wirh this for 5 minutes, it looks perfect.
TerraRoot
Clever girl..
I think it's cool as fuck, i'd print and ride the street version, adding perhaps some tensioned threaded rod in critical spots. Also probably a little more R&D into that front end, equal length arms make the ride a bit crude.
Just need a fuckn really expensive massive printer!
Thanks, goes super well with the purple frame (stickers by my then 4yo)
Yep, ripped around a hard right, then merged onto dual carrigeway for all of 40 seconds of flatout (bike is to slow to legally travel there) pulled off and when I went to change down it went clack instead of snick, I stopped and looked, lucky is right.
what's funny is the other end is massivly over braked, 200mm floating disc, radially mounted 4 piston caliper and a radial master cylinder.
On a bike that can do (GPS verified!)
96km/h
The smaller it is, the more power, and the sooner you melt the piston from the retained heat/pressure.
Don't think of two stokes as three simple moving parts, they are one almighty pipe and a not that important engine.
I'll look them up soon, thanks!
Ping pong - lil sis nora and that aronchupa guy
Got an sv08 as an upgrade from a ender 3 v2, it's quite the improvement, it's been faultless, hit print and forget.
Negatives are the firmware updates (Files could be way better organized/handled) and I suppose if sovol ever dissappeared getting nozzles might be a pain.
Really glad I got it.
Motorcycle rides are the best gym&diet, I can forget to eat on my days out, but if you want to lose weight quicker and have fun, get a trail bike and get muddy!
So both. I have the most meticulously planned 90% complete projects.