ShadowRam

This is a variation of my 3 PIN LED Strip thing 6123191. This is for 12v 10mm LED strip lights. The height is 4mm so it doesn't add height to the height of my pictured IP65 strip. Yes, it's not soldered but you can see the wires fit. 9/20/2023 Update: Added info that this is a Remix of https://www.thingiverse.com/thing:5223739

Design by @canthidium

SkyWatcher Star Adventurer is my grab and go kit for astronomy and I take it with me abroad too. I dont want to carry around steel counterweight when Im abroad, especially air travel with them can be costly. So I came up with this solution that holds two 0.5l cans to use as counterweight. On the V2 Ive also included screws and fitting threads unlike in the photo of the V1 with metal bolts and nuts.

Various knobs for cylinder head screws with M3/M4/M6 or M8 thread. For explanation, I have designed two different versions. The standard version has a hexagon socket integrated in the knob. The screw is inserted or glued onto this, whereby the thread length of the screw remains the same. The "thread" - version is for high stress when turning with a very large torque. For this purpose, the screw is screwed into the knob and glued in place. This shortens the screw by approx. 5 mm, but the connection is extremely strong and resilient.

Simple hooks on bracket designed to fit on VW T5. may fit other VWs can be printed on FDM or resin (I would advise a thicker wall with good drainage if resin, a solid print will not endure well)

A funny little cartoon and this video is not made by meFrog Joe Cartoon in a BlenderYou can find all the video's at http://joecartoon.comLet me know at the c...

A public service announcement courtesy of GI Joe

Paint mixer model 2 The hole is 8mm with tolerance already applied. If you are interested in supporting my work and possibly having access to the original STEP file of this model, you can receive it with a small donation. The donation is voluntary, but any contribution is appreciated. Thank you for your support!

Door mounted container for sauce/gravy packets. Approx. 1.5in deep. Use a single 5lbs capacity command strip to mount.

This is a spoon that allows fast and precise spooning. You can easily fill your smallest and largest dessicant containers without spilling the tiny pearls - say goodbye to funnels. The unscaled spoon can hold ~12ml that is 10g of silica-gel pearls. Simple print, no supports, three walls, can be scaled if needed

This is an upgrade for the "Parkside Multi Grinder Holder" by rechena. Please also check the source creator. The changes are the following: The lower rear part has been reduced in height. The front part has been reduced in height, different for Parkside and Dremel. These changes were made to ensure the horizontality of the tool. Centering nuts were added, because the front support hole is wider. (3/4x12 for Dremel and 18x1.5 for Parkside) Screws have also been added to keep the original nuts when not in use. It is recommended that the nuts and screws be printed with the wider side down and at the finest resolution to ensure thread quality. Note: Fits Dremel 4000 and Parkside PFBS 160 C3

Exact same file as the one posted by HarderDIY just with the model rotated so it prints on end. Find it easier to remove the supports that way. I printed at 0.75 scale for a more reasonable size for a keychain. I may re-upload this with the prongs on the male end separated a touch as it has a bit more play than I would like when buckled together. EDIT: This is maybe not the best idea at 0.75 scale with PLA... broke in less than 24 hours due to the layer direction I think...might be better with PTEG or better layer adhesion. My printer isn't tuned the best right now so might be a me problem ahaha