Can someone ELI5 this to me?
LazaroFilm
joined 2 years ago
In cura switch to the preview mode to see the paths your printers will lay plastic at. It will tell you a better idea of what your final product will look like.
I actually sat down and did this manually for myself. It was worth it.
It’s at the top of a mountain.
I wish there was a 2D printing community like for 3D printing where you could build your own printer and run it off a Raspberry pi.
I like my canon with the megatank. No more cartridges. You can buy cheap 3rd party inks and refill when needed. It’s not open source but the drivers aren’t invasive. It has wifi but I didn’t set it up and just use usb.
That was the best pun. It’s all downhill from here
Every time I see those letters I think about the fact that I spent years not realizing that the movie Welcome to GATACA is a gene sequence.
That the name of the magazine!
You could make it an app switcher like CMD+Tab and CMD+Shift+tab for each direction.
NSFW!
Shitters clogged. — lightning.