I have switched out the fan duct and heat block (to use normal volcano) on mine as the only HW changes, and then I've flashed the main board with klipper. Using klipper has been a crazy step up in printing quality over the stock firmware because it gave me the control needed to do a proper tuning of my printer.
ExcessShiv
joined 1 year ago
I mean, they're definitely good enough for me but resin does give much better fine details. But I also mainly use my printer for functional prints, this is just a nice addition to its uses.
I'm pretty happy with the goblin and skeleton, the orc's bow is a little wonky at the top because my layer time was too short for my printers cooling. None of these has had any post processing done yet, printed without any supports also 0.2mm nozzle and 0.08mm layer height.
I think I'll try printing a sort of "buffer tower" next time to increase layer time on prints with pointy tips and see if it helps.
Yeah i probably could, there's definitely some supports that were not needed that I could have avoided...but for fully auto-generated supports I think it did a pretty good job.
Jeg har et familiemedlem der valgte ikke at blive skolelærer efter sin praktik, fordi vedkommende opdagede at det simpelthen ikke var muligt at undervise på en måde de mente var en ordentlig under de rammer der kunne gives i folkeskolen.
An omnipotent and omniscient being probably doesn't give a shit about which language you use...or, being omnipotent, you actually can't address it in any other way than it wants you to.
Jesus fucking Christ buddy, calm down you crazy bastard...
You state theres a 30% increase in travel speed...but there isn't, it's literally the exact same speed as the normal sv08.
Are you comparing to some random other printer from another manufacturer?
The regular sv08 also has 700mm/s max so I'm not sure where you're getting the 30% increase from
Super 👍 det bliver en bøf, gennemstegt tak
Nej det kan du have ret i
It's a US based company, and judging by your use of Euro I'm guessing you're in Europe...it's expensive to import stuff from the US, that shipping cost probably also covers VAT. Check out servershop24.de if you're in Europe