CIA_chatbot

Oh what about that bearing? Maybe the bearing is going out?

Actually, when you put it that way - I can totally see your point I have 3 large footprint printers but x and y are really what used most, for big z index prints I have a print mill

You sonuva bitch, I’m in

Are the teeth worn down? Maybe it’s time to replace the gears. (Throwing stuff at the wall here) other than that it sounds like maybe there is a piece of filament stuck somewhere rubbing against the gear?

800x800x 200??? That’s the weirdest damn dimensions

Participating in sports is now for “internet points?” Downhill skating has been around since the 70s

~~ haven’t seen anyone mention this somehow, but this is most likely caused by a draft hitting that part of the print and causing it to cool at a different speed than the rest. Easy test, get a big cardboard box and put it over the printer and redo the print. You might need to invest in a cheap printer enclosure ~~

Edit: never mind I totally missed the part where you mentioned you had a heat enclosure

Not with attitude

They’ve tried multiple times, so far the Idaho Supreme Court has blocked them, but other times they’ve simply reversed the ballot passed initiative after it passes. Idaho Republicans are the fucking worst republicunts of all the cunts

It was hollow inside, we promised not to tell in exchange for them not telling on us for faking the moon landing

Wel shit, now I’m curious, not like anyone will be around when the timeline ends.

So we can track how long it takes until reality unravels….. I don’t know, humans just like to count things?