If you're worried about people slipping you really gotta reinforce that handrail first my friend. That's nowhere near strong enough to hold up when someone is putting all their weight on it
DIY
For DIY - this is also a placeholder.
I'm really curious what it looks like underneath as well. From everything in view it's not built for much strength.
Agreed, need a rail on the otherside and/or lips added to the edges so wheelchairs don't launch off the side at speed of things get slippy.
If slipping is a concern, you should also put up a better railing.
The building codes in most places would require balusters or otherwise closed in sides on a ramp like this. If someone does slip, they can go under the rail and off of the porch/ramp.
Also, the vertical supports for the hand railing seem insufficient. Supports for railing are generally 4x4, connected with bolts, and there would be a couple of more of them on the long run. A 200lb+ person falling has more than enough force to snap some screws through a 2x4.
Grip tape? There's a ton online you could order, or hit up your local hardware store. May kinds are designed for outdoor ramp/stair use.
So many crazy ideas in this thread. This is the obvious solution.
That and reinforcing the railing, thing looks flimsy af.
This is what I was about to suggest. Grip tape the crap out of it.
Heated de-icing system would be ideal. Can’t be slippery if it’s warm.
Ben Shapiro agrees.
Second this idea.
Yes, this is safest for the elderly, but also still adding rubber or like metal ledges is still worth it I think (wet wood like in the pic can become slippery over time).
Since it's a small area you can set the heating coils (or hot water of you go that way) on a timer (like they press a button/flip a switch a few minutes before going out) ... or maybe even rig the whole thing directly w/o a battery to a solar panel & let it run all the time (solar panel doesn't need to be placed ideally, vertically under the roof is probably fine so you don't have to clean it).
Also if it works out for you, you can then extend the same system beyond the ramp (like a trail to the garage or whatever).
Had one like this and way longer so it was hard to find a solution. We ended up using sand and clear UV resistant polyurethane as a grip surface. You can either mix them together and apply with a roller, or brush on poly and sprinkle on sand like you're salting a roast. We did the later and it's lasted for years
Prime it and then you can purchase "outdoor porch floor paint" that has a bunch of grit in it. I did this for outdoor steps also made of wood and I'm living where we get a lot of snow and ice. It's not perfect, because the grit isn't raised too high, but it's a heck of a lot better than it is without it.
If it's typically clear, grip tape would be best. If you expect snow to hang around, you might want to add furring straps. You'd want them to be fairly short, though, to make sure they aren't a tripping hazard
There is a special powder (look up slip resistant additives) that you can mix with paint to create a surface with a lot of traction.
Mix grit into deck paint and lay it on thick.
Grit tape between the slats you plan to add. If it's just for winter (??) then you don't need it to last too long.
Depends where winter is
Fair point
My two ways to go about it would be:
- the mentioned rubber mats and a roof so they don't snow over
- a metal grating with enough of a offset of the ground/ramp that snow can fall through/get pushed through and be periodically removed from below the grates. (Maybe remove the planks and replace them with gratings.)
Hope this helpes.
The best technique is not to modify the ramp but get people to use spikes on their shoes. The ramp will almost always be icy/snowy during winter and it will be difficult to stop this or remove ice without damaging the wood.
I have something like this. I got mine at Costco (check now, it's seasonal): https://www.amazon.com/Yaktrax-Spikes-Walking-Large-X-Large/dp/B01IB76JTY/ref=sr_1_23?keywords=shoe%2Bspikes%2Bfor%2Bwinter&qid=1699053381&sr=8-23&th=1
And if people use this you probably want something on that wood to protect it from the spikes. I suggest this or similar: https://www.amazon.com/ZGR-Outdoor-Profile-Entryway-Non-Slip/dp/B08N5WFJ1Z/ref=sr_1_6?keywords=outdoor+runners&qid=1699053563&sr=8-6
A runner like this also allows whoever maintains the ramp to "shake off" snow and thin ice.
No perfect solution, IMHO. But I think this would work best. This will also help those people wherever they walk.
That's a good idea regardless of what we do on the ramp. Thanks!
ITT: people trying to help, without reading the post
I'm finding Lemmy is just as bad as Reddit about people just reading headlines
Could you not just make a roof? Wouldn't have to be anything crazy, just a tarp over a simple frame, otherwise if you don't mind spending a bit of cash, there's these heated ramp mats
I think non-slip rubber mat with grooves was the right idea, this is what is used in ski resorts.
However they are usually installed on top of grids that let the snow and ice pass through the grooves.
is this ramp used by somone in a wheelchar if not i would thin the easyest soulution is to just take some wood and screw it in along the ramp to make "steps"
Occasionally we push someone up with a wheelchair but most of the time they're walking. I debated the wood idea but it will make shoveling the ramp off much more difficult.
space the out so you can get your shovel in between and push the snow off the side
Cleats, because if that's slick enough to endanger an older person, then they should probably be wearing them on the sidewalks too.
Would adding "studs" be possible?
Screw a shit ton of short weatherproof decking screws into the wood but leave them slightly raised instead of countersunk.
Might make it pretty difficult to shovel snow off though.
Something like this? We have it on our steps. Just the first link that popped up, I don't know anything about that particular brand or seller.