I am wondering how you handle balance with these. Do you worry about that and if so, how do you ensure all sides are equally probable?
this post was submitted on 26 May 2025
107 points (99.1% liked)
Clacksmith
379 readers
48 users here now
A place for all things about dice making. Ask questions, get advice, show off your creations!
founded 2 years ago
MODERATORS
It’s a bit of a crapshoot. The weight of the black vs the colored with additives is very minuscule. It might show in a float test but in normal use not so much. If I used something like mica powder for a portion of the die that might add more weight to a side. White pigments tend to be a bit heavy so I use them sparingly and make sure they are well mixed. I do try to avoid additives that sink. I have a box of shame for glitters and flakes that sink because they would throw off the balance slightly.
The biggest factor that would throw off weight is bubbles and I do a lot to prevent those. The resin goes through a vacuum chamber with vibration after mixing and the dice cure in a pressure pot to eliminate bubbles completely.
These look amazing!
Looking sharp. (Pun intended.)
You got less than 50 upvotees over 2 weeks ago. What are you talking about?
50 is a lot my guy. Not to mention other communities where they received a positive reaction.
Also, the other set like this got almost a hundred where I usually get around 50