Hello folks!
I'm having troubles by configuring Mullvad Wireguard VPN through VPN Fusion on my ASUS GT-BE98 running latest firmware version (3.0.0.6.102_34372).
I followed the (insufficient) instructions step by step but the VPN doesn't connect.
I tried with other VPN Services like NordVPN, Express VPN and SurfShark VPN and I have no issue at all.
I don't want to use OpenVPN because of obvious reasons.
I generated a Wireguard Key trying both Linux and Android/ChromeOS but it still doesn't work.
I setup the profile in this way:
Country: Italy
City: Milan
Server: it-mil-wg-001
Multihop: tried both enabled or disabled but same results
Server connection protocol: IPv4
Tunnel traffic: IPv4 only because my ISP doesn't support IPv6 (tried also "both", same results)
Custom port: 51820 (it's the default value)
Enable Kill Switch: not flagged
Content blocking: None
Then I downloaded the .conf file and I imported it on my GT-BE98; I just clicked on "Apply and Enable", rebooted the router and after reboot it always says "Tryng to connect..."
I can't figure out where the issue is. Is there anyone who can assist me?
PS: my Router doesn't support OpenWRT and even if it did support it I would never install it.
Thanks!