this post was submitted on 05 Oct 2023
16 points (80.8% liked)

homeassistant

15814 readers
4 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
GreatAlbatross@feddit.uk
greatalbatross@lemmy.world
16
Dreametech L10s Ultra won't clean - it demands to be returned to base (lemmy.d.thewooskeys.com)
submitted 2 years ago by mike_wooskey@lemmy.d.thewooskeys.com to c/homeassistant@lemmy.world
6 comments fedilink hide all child comments
 

My new Dreametech L10s Ultra has been great so far and it does fine on my main floor (with the base station) and in my basement. But when I take it to my 2nd floor, it positions correctly and says "start cleaning", but then it spins once and says "please return robot to the base station". It already successfully mapped the 2nd floor.

Has anyone experienced this? Why does it sense where it is and begin cleaning, but then immediately stop and need the base station? It's done it numerous times. The battery is fully charged, the mop pads are cleaned and dried.

Thanks for any assistance or ideas.

you are viewing a single comment's thread
view the rest of the comments
[–] EddyBot@feddit.de 5 points 2 years ago* (last edited 2 years ago) (2 children)

On Dreame robot vacuums you can actually flash your own firmware like Valetudo which is also quite popular in Home Assistant peers since it no longer phones home

[–] NeoNachtwaechter@lemmy.world 1 points 2 years ago

That's good news!

[–] Brtrnd@feddit.nl 1 points 2 years ago

It's not really firmware, its a software solution that blocks it from phoning home. It still behaves the same.