3dprinting

65 readers

1 users here now

founded 7 months ago

MODERATORS

j4k3@lemmy.world

j4k3@piefed.world

Made a series of TPU plugs for electrical conduit getting embedded in concrete foundations. (infosec.pub)

submitted 1 month ago by j4k3@piefed.world to c/3dprinting@piefed.world

6 comments fedilink hide all child comments

Made a bunch of 3/4in and 1in plugs last week but just made a 2in pictured. It is a thing that does not exist, which seems silly obvious. This goes in the concrete just below the surface so they can polish it before these plugs are broken out with a hammer and wire gets ran.

you are viewing a single comment's thread
view the rest of the comments

[–] BCsven@lemmy.ca 1 points 1 month ago (1 children)

If the top bevel was opposite you could pull it out after concrete was poured/polished since it would have draft, instead of trapped by the angle

[–] j4k3@piefed.world 1 points 1 month ago* (last edited 1 month ago) (1 children)

Might get knocked out or loose.

[–] BCsven@lemmy.ca 2 points 1 month ago

True , good point.