this post was submitted on 10 Dec 2025
22 points (100.0% liked)
WomensStuff
787 readers
155 users here now
Women only trans inclusive This is an inclusive community for all things women. Whether you're here for make up tips, feminism or just friendly chit chat, we've got you covered.
Rules…
- Women only… trans women are women, and transphobic or gender critical talk isn’t allowed. Anyone under the trans umbrella (e.g. non-binary, bigender, agender) is free to decide whether a women's community is a good fit for them.
- Don’t be a dick. No personal attacks, no aggression, play nice.
- Don’t hate on groups, hatefilled talk about groups is not allowed. Ever.
- No governmental politics, so no talk of Trump actions etc. We recommend Feminism@beehaw.org for that, but here is an escape from it.
- New accounts or users with few comments may have their posts removed to prevent spam and bad-faith participation.
founded 9 months ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I changed the sink faucet. I've done it before, but this time I didn't have to crack that bitch-ass nut off since I got the glorious BASIN WRENCH.
Omgosh I need to replace a faucet so badly and this could be the push I need to get it done! Thank you!
(Well except for the part that the sink was installed without cutoffs 😅)
I'm telling everyone about it. The basin wrench was only $15 too!
You can install cut-offs, a process that ranges in difficulty depending on your set-up, but you can buy the valves. Soldering plumbing is super easy if it's copper, you just need a torch, flux and solder, like $20-$30.
Oh I'm mostly just complaining about my main water cutoff being a quarter mile from the house, haha.The actual inlet pipes for the sink are CPVC, so theoretically even easier to add the cutoffs 🤞
Ohh gotcha. That's way easier, and I wish you luck!
Thanks much! ❤️