homeassistant

16739 readers

14 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

How do you name your devices and entities? (lemmy.world)

submitted 6 days ago by early_riser@lemmy.world to c/homeassistant@lemmy.world

24 comments fedilink hide all child comments

It would seem logical to name them for where they are and what they do. "Bathroom motion sensor", "Bedroom lamp", etc. However, I've found that, if it can move, it ends up moving sooner or later. My "bathroom" motion sensor is now in the upstairs family room, for example.

you are viewing a single comment's thread
view the rest of the comments

[–] lka1988@lemmy.dbzer0.com 1 points 5 days ago* (last edited 5 days ago)

Depends how it's implemented.

For example: I'm in the process of replacing my Wyze wifi bulbs with ThirdReality Zigbee bulbs (only 3 left to swap).

What I do is remove the Wyze bulb from the Wyze app, then go into HA and refresh the Wyze integration which removes the bulb's entities from HA. Then I'll do the physical replacement, pair the Zigbee bulb with HA, give it the exact same name as the Wyze bulb (this is key), then go check the automation(s). Haven't had any issues with that so far.