this post was submitted on 13 Oct 2025
36 points (95.0% liked)

homeassistant

17762 readers
15 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
GreatAlbatross@feddit.uk
greatalbatross@lemmy.world
36
Can I connect two 24v strips to this? (infosec.pub)
submitted 3 months ago by Nurgus@lemmy.world to c/homeassistant@lemmy.world
11 comments fedilink hide all child comments
 

As you can see, it has 2 of each terminal. The supplied wiring diagram only shows one being used. I have two identical 24v strips that I want to dim together - can I just wire them both in?

you are viewing a single comment's thread
view the rest of the comments
[–] sven222@soc.hardwarepunk.de 2 points 3 months ago

@Nurgus Mostly yes. Check if the currrent is enough to drive both stripes. Sometimes LEDs can make problems if they are connected paralell to a power source, cause they have minimal different forward voltages, but stripes who are allready on 24V should not have that problem. Try it out.