3DPrinting

19624 readers

208 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

andypiper@lemmy.world

j4k3@lemmy.world

GrayBackgroundMusic@lemmy.zip

Adhered so hard it delaminated the glass. (sh.itjust.works)

submitted 3 days ago by hereiamagain@sh.itjust.works to c/3dprinting@lemmy.world

48 comments fedilink hide all child comments

I loved this glass bed. After so much time trying to get anything to stick to the stock ender 3 bed, this glass bed has things sticking almost TOO well.

It was fine enough for PLA, but I've been playing with PETG lately and it sticks a little harder.

Well today I printed the entire bed flat for a little hiking table I'm experimenting with.. and this happened when I tried to get it off...

Suggestions for replacement? Should I go glass again? I don't have bltouch so I like how flat glass is, set it and forget it. But I've seen those magnetic plates that allow for super easy removal but just flexing the plate, but this bed is aluminum I think. Plus that seems similar to the stock ender 3 plate that I despise.

you are viewing a single comment's thread
view the rest of the comments

[–] Thorry@feddit.org 4 points 2 days ago (1 children)

I keep a very sharp scalpel next to my printer. It's super thin and a bit flexible, but still has a sturdy handle to hold on to. With it I can get in between the glass and the PETG no matter how stuck it is. Once I cut a little bit, usually the whole print lifts right away.

[–] hereiamagain@sh.itjust.works 4 points 2 days ago

I do this too, normally it works a treat.