I borrowed some landscaping tools from my brother in law and he offered his old air compressor since he doesn't use it. Broken tube. Easy normal part to replace.
Got a air compressor accessories kit on the way home. Replaced the hose and tip. Plugged it in outside. Left it for 10 minutes...
Never turned off. Hmm. Might be one of those that have a release valve and not auto shutoff.
20 PSI? That's odd. Unplugged it. Hissing...
Air coming out the bottom. Maybe a puncture?
Found the spot. Got 80 grit sandpaper and 3300 PSI rated epoxy. Sanded and found rust.
Patched it and my spidey sense went off while looking at the epoxy...
Did a search:
A leaking air compressor tank—especially with a leak on the bottom where corrosion is likely—can be extremely dangerous, even if "repaired" with epoxy or other sealants. The primary risk is catastrophic rupture under pressure. If the integrity of the tank is compromised (for example, by internal rust or a patched-up hole), the tank can explode with explosive force, launching shrapnel and causing severe injury or death, as well as property damage
When tanks rupture, the velocity of air and shrapnel can be lethal. For example, a 60-gallon tank at 150 PSI can explode violently, creating 680 mph air blasts and extremely loud noise, both of which are highly hazardous for bystanders
Nope! Tossing it!
Dodged a nearly literal bullet there.
Bonus shots:
Air is dangerous as well. A hydraulic system quickly loses energy on failure because oil is nearly incompressible.
Compressed gases or liquids that are beyond their boiling point at atmospheric pressure store a lot more energy at pressure and release it a lot more violently than hydraulics when experiencing a surprise decompression.
Let's take a 100 liter compressor tank that's buffering at 10 bar:
For an isothermal expansion from high pressure to atmospheric pressure, the energy is:
E = P₁V₁ ln(P₁/P₀)
Where:
P₁ = 10 bar = 1.0 MPa
V₁ = 100 liters = 0.1 m³
P₀ = 1 bar = 0.1 MPa (atmospheric pressure)
E = (1.0 × 10⁶ Pa)(0.1 m³) ln(10)
E = 100,000 J × 2.303 E = 230,300 J (or about 230 kJ)
TNT releases approximately 4.6 MJ/kg of energy. 230,300 J ÷ 4,600,000 J/kg = 0.05 kg or 50 grams of TNT
Of course a tank rupturing will expand a lot slower than TNT, but the energy is the same and when half of the tank shell points towards some offices next to the workshop, the first three walls will be impressed pretty much the same way by the suddenly very agitated piece of steel.
Had an air tank fall over in a stupid way during refilling at our local fire station last year. Valve broke off at nearly 270 bar and the thing went off. Now there are new rules, new indents in the concrete walls and at least one fireman that reacts a bit jumpy to "clang" like sounds.
I think they just blanked for a moment and forgot air was a fluid. Pressure is crazy dangerous in all forms. Insert peer pressure joke
Big agree. Air can scare. Steam is worse because of condensate.
you sure the high temperature and thermal mass of steam isn't slightly worse than condensation?
The condensate is still way over 100 degrees due to pressure. If it reaches the top of the pipe it can create a shock wave (think water hammer) that will travel to the next corner and blowout. The condensate then turns back to steam at atmospheric pressure.