this post was submitted on 23 Jan 2025
95 points (74.1% liked)
Sysadmin
10552 readers
1 users here now
A community dedicated to the profession of IT Systems Administration
No generic Lemmy issue posts please! Posts about Lemmy belong in one of these communities:
!lemmy@lemmy.ml
!lemmyworld@lemmy.world
!lemmy_support@lemmy.ml
!support@lemmy.world
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The lights are combined link/act, not separate link act. left for upper side, right for lower side. 2 and 4 are blinking, 1 and 3 (the empty ports) are not.
So #5 is disconnected on the other end, right?
Yes, or the systems etc. Or the port is disabled if the switch has the ability.
Could've also just caught the photo in a flash of down activity depending. Still tho.
It's a gif and the LED is permanently off.
Port 4 is slightly pulled out, you can see the cable difference between 2and4. which I think is what OP was getting at.
It's probably touching just enough pins to keep active
It doesn’t seem to be, they look like different cables, look at the strain relief after the clear part, looks like a different pattern and shorter. They are probably both fully seated.
Hmm maybe I was wrong. Either way I think we can both agree this is everything just working normally...
Really? I've never seen that. In my experience, those labels are for the ports themselves, not the lights.