this post was submitted on 24 Dec 2024
356 points (97.3% liked)
homeassistant
19098 readers
1 users here now
Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.
Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation
Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Those dht11 sensors are garbage tho. Best case they are wildly off on their humidity sensor. Worst case they keep breaking and shows nonsense readings. I would recommend bme280 sensor instead. If you read about them you might see people complain that they are reading too high temperatures, but in my experience its because they are misconfigured. Default settings have a very high sampling rate of multiple samples per second that heats up the sensor a tiny bit giving you the offset. Lowering the sampling rate or turn the sensor off completely in between readings gives really precise measurements on both temperatures and humidity.
+1 on BME280 vs the DHT. I don't know why the DHT are so expensive, they're pretty bad.
Yea I've considered recommending thr DHT22 instead, but I was trying to keep costs as low as possible, and honestly I've had pretty good results thus far (calibrating with other systems, anyway).
Bme280 is actually just as cheap if not cheaper than the dht sensors. But its a fair point trying to keep the cost down. I definitely like that philosophy, but if the quality suffers too much it's just not worth the trouble. Keep up the good work. 😎
Oh good to know, will investigate!