homeassistant

15727 readers

7 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

Light switch advice (lemmy.world)

submitted 11 months ago by skullvalanche@lemmy.world to c/homeassistant@lemmy.world

18 comments fedilink hide all child comments

Just looking for some advice if the idea I have in mind is even feasible.

I have 2 light switches in my kitchen, one for some pendant lights, one for some overhead cannister lights.

I hate the placement of the switches, since the pendant lights which I prefer are far away from the actual doorways into the kitchen. Meanwhile the cannister lights are on the switches near the doors.

I'm looking to do some clever "hackery" to make it so the switches by the doors control the pendant lights, if possible, but I don't want to have to rewire things in the walls/ceilings.

Is there a good solution to this? I was looking at some Shelly switches, but I'm not sure those solve for the problem I wanna solve. I'm willing to swap out switches or wire in things near the lights, but trying to keep things simple as possible.

you are viewing a single comment's thread
view the rest of the comments

[–] greyfox@lemmy.world 1 points 11 months ago

The switches don't have to control the lights they are wired to. I have Inovelli z-wave switches, and on these you can disable the relay. So the switch can still send out commands/scenes on the network but the relay is always on.

Then you would put in a relay unit in the electrical box of the lights or if you have enough room in with the switches. Then setup the switches to control their respective sets of lights.

Might even be a switch out there that lets you disconnect the relay from the buttons on the switch but still control the relay which would cut down on the device count.